Turbelle® nanostream® 6055
Turbelle® nanostream® 6055
Turbelle® nanostream® 6055
Turbelle® nanostream® 6055
Turbelle® nanostream® 6055

Turbelle® nanostream® 6055

For aquariums from 40 to 500 liters (10.6 to 132 USgal.).
Flow rate: 1,000 to about 5,500 l/h (250 to about 1,450 USgal./h) with Turbelle® Controller
Energy consumption: 4 - 18 W
Power supply unit: 100-240V / 50-60Hz
Cable length: 3 m (118”)
Dimensions: ø70 mm (2.7”)
Output: ø40/15 mm (1.5”/2/3”)
Magnet Holder with Silence clamp up to a glass thickness of 15 mm (2/3”).

Instructions for use
All matching accessory articles
6055.000
198,20 EUR
Including VAT: (19,00 %)



Specifications

nanostream® design

nanostream® design

Turbelle® nanostream® electronic are speed-controlled pumps with a Turbelle® controller operating on safety extra-low voltage, to be employed ideally in every aquarium from 40 to >1,000 liters (10 to >265 USgal.) for simulation of lapping waves or tidal currents. They contain a microprocessor-controlled motor and a Turbelle® controller. The electronic motor adapts its speed automatically to the pump load and always seeks the best efficiency at the lowest possible consumption of energy. The pumps will be stopped immediately in case of blockage. After the blockage has been removed, the pumps will start up automatically after a delay of 20 seconds. The pump driver has been provided with a fish care function, which causes a revolution of the propeller every twenty seconds when the pump is at a standstill.
Apart from that, the pumps can also connect to devices controlled by the SmartController via the TUNZE® HUB.

The Turbelle® controller is a...

device that is used to set the variable pump performance. It can provide a wave simulation, oscillation flow, an automatic search for the resonance frequency when the oscillation flow is used, and it is also equipped with a food timer. It can be directly connected to a SmartController 7000. The pump is therefore able to operate together with other pumps, for example, in the high/low tide mode. If the Moonlight 7097.050 (not included in the scope of delivery) is attached to the Turbelle® controller, the night-mode operation will be activated automatically. If this controller is connected to a second controller with the 7092.300 cable, a further pump can be connected and controlled, for example, to provide a wave pounding simulation or an oscillating current. A third controller can be added using the Y adapter cable 7090.300.

Flow profile

Flow profile

Safety extra-low voltage, blocking and...

run-dry protection.

Controllable speed, wave simulation, tidal...

currents

Low motor heat

3D adjustment

Includes Magnet Holder

Includes Silence clamp

Propeller technology

All matching accessory articles

Safety Connector

Safety Connector

Enables normal operation using the TUNZE® power supply and will switch to a battery or DC supply automatically in the case of a power failure.

6105.500
74,30 EUR
Including VAT: (19,00 %)
Moonlight Turbelle®

Moonlight Turbelle®

With photo diode. Simulates a 29-day moon phase and controls the night-time reduction at pumps with a Turbelle® controller add-on or together with SmartController 7000. Suitable for all Turbelle® electronic...

7097.050
39,60 EUR
Including VAT: (19,00 %)
Cable 1.2 m (47.24") Turbelle® controller

Cable 1.2 m (47.24") Turbelle® controller

Connects two Turbelle® controllers for a simultaneous controlling or connects one Turbelle® controller with a SmartController 7000.

7092.300
12,80 EUR
Including VAT: (19,00 %)
Y adapter cable

Y adapter cable

Connects two Turbelle® controllers for simultaneous controlling. An additional third pump or Moonlight 7097.050 can be connected. Connects SmartController 7000 with Turbelle® pumps and / or TUNZE® LEDs or the...

7090.300
23,70 EUR
Including VAT: (19,00 %)
Turbelle® controller add-on

Turbelle® controller add-on

The Turbelle® controller is a pump controller for all Turbelle® pumps with an electric motor, which is used to set the variable pump performance – especially for models without an...

7090.000
56,40 EUR
Including VAT: (19,00 %)
Multicontroller 7095

Multicontroller 7095

The TUNZE® Multicontroller 7095 is a digital control device for all Turbelle® pumps fitted with an electronic motor. It simulates the various maritime flow conditions within the aquarium, contains an...

7095.000
0,00 EUR
Including VAT: (19,00 %)
Temperature Controller

Temperature Controller

The Temperature Controller is a compilation consisting of the SmartController 7000 and its appropriate switching socket, the Controlled Power Socket 7070.120 in a separate package.

7028.000
0,00 EUR
Including VAT: (19,00 %)
Nanostream® Rock

Nanostream® Rock

For Turbelle® nanostream® 6015, 6025, 6045 and 6055. Consisting of a highly porous ceramic stone with Live Rock Function, suitable for fresh and sea water, and a high water flow...

6025.250
62,40 EUR
Including VAT: (19,00 %)
Cable guard

Cable guard

Cable protection hose, length 33 cm (13 in.), suitable for the cable of the Turbelle® pumps, for example, to protect against damage by sea urchins, if the pump is located...

6040.019
1,90 EUR
Including VAT: (19,00 %)
Magnet holder

Magnet holder

Universal holder for attachment up to a glass thickness of 20 mm (¾")
Dimensions: ø50 mm (1.9") x W15 mm (.59")

6025.500
58,40 EUR
Including VAT: (19,00 %)

The prices listed in the catalogue are given in EUR and contain a value-added tax of 19%. Additional information: