Turbelle® nanostream® 6055

Turbelle® nanostream® 6055

For aquariums from 40 to 500 liters (10.6 to 132 USgal.).
Flow rate: 1,000 to about 5,500 l/h (250 to about 1,450 USgal./h) with Turbelle® controller
Energy consumption: 4 - 18 W
Power supply unit: 100-240V / 50-60Hz
Cable length: 3 m (118”)
Dimensions: ø70 mm (2.7”)
Output: ø40/15 mm (1.5”/2/3”)
Magnet Holder with Silence clamp up to a glass thickness of 15 mm (2/3”).

Instructions for use
All matching accessory articles

6055.000
188.69 USD
Including VAT: (0.00 %)



Specifications

nanostream® design

nanostream® design

Turbelle® nanostream® electronic 6055 and 6095 are speed-controlled pumps with a Turbelle® controller operating on safety extra-low voltage, to be employed ideally in every aquarium from 40 to >1,000 liters (10 to >265 USgal.) for simulation of lapping waves or tidal currents. They contain a new microprocessor-controlled motor and a Turbelle® controller. The electronic motor adapts its speed automatically to the pump load and always seeks the best efficiency at the lowest possible consumption of energy. The pumps will be stopped immediately in case of blockage. After the blockage has been removed, the pumps will start up automatically after a delay of 20 seconds. The pump driver has been provided with a fish care function, which causes a revolution of the propeller every twenty seconds when the pump is at a standstill. It can be controlled by Multicontroller / SmartController 7000.

Electronically controllable synchronous motor pumps - Turbelle® Controller included

Electronically controllable synchronous motor pumps - Turbelle® Controller included

The Turbelle® controller is a device that is used to set the variable pump performance. It can provide a wave simulation, oscillation flow, an automatic search for the resonance frequency when the oscillation flow is used, and it is also equipped with a food timer. It can be directly connected to a Multicontroller / SmartController 7000. The pump is therefore able to operate together with other pumps, for example, in the high/low tide mode. If the Moonlight 7097.050 (not included in the scope of delivery) is attached to the Turbelle® controller, the night-mode operation will be activated automatically. If this controller is connected to a second controller with the 7092.300 cable, a further pump can be connected and controlled, for example, to provide a wave pounding simulation or an oscillating current. A third controller can be added using the Y adapter cable 7090.300.

Flow profile

Flow profile

Safety extra-low voltage, blocking and...

run-dry protection.

Controllable speed, wave simulation, tidal...

currents

Low motor heat

3D adjustment

Includes Magnet Holder

Includes Silence clamp

Propeller technology

What is it that makes the Turbelle® propeller pump so special?

What is it that makes the Turbelle® propeller pump so special?

Very silent operation
Special synthetic or magnetic bearings and the Silence holder included as standard enable very silent operation.
Flexible 3D adjustment
Unlike other pumps, the Turbelle® provides important flexibility regarding positioning and direction of the water jet. The water jet can be directed in such a way that a long distance in the aquarium is covered, producing an efficient current at low power consumption.
Large intake surface
The big intake strainer prevents early soiling and protects the animals against being sucked in.
Eco-energetic
High-performance motors with eco-energetic concept offer very high efficiency at very low maintenance requirements and power consumption.
Controllable performance
The safety extra low voltage, electronic speed-control Turbelle® is ideal for use in any aquarium with wave or high/low tide simulation. Its intelligent microprocessor-controlled motor together with Multicontroller or SmartController 7000 make an invincible team.
With Magnet holder as a standard
The Turbelle®, as a standard accessory, features a magnet holder for easy fixing anywhere on the aquarium pane.
Power failure – no problem
The electronic speed control Turbelle® can be operated by any 10 V to 24 V DC supply (battery, solar cells) using the Safety Connector. The Safety Connector enables normal operation using the TUNZE® power supply and will switch to a battery or DC supply automatically in the case of a power failure.

In addition to the lighting...

conditions, the current flow is the most important parameter within the aquarium, especially for saltwater biotopes. The following examples explain which flow situations can be found in different reef zones, and how they can be reproduced with Turbelle® flow systems.
The recommended combinations are suitable for aquariums from approx. 200 to 2,000 liters (from 52 to 528 USgal.). Further recommendations, specific examples, or recommendations for freshwater biotopes can also be found on our website in the TUNZE® configurator section at www.tunze.com, or they can be requested by email.

Beach zone / algal zone

Beach zone / algal zone

Medium-strong and gentle oscillating current. This sandy zone is frequently inhabited by algae and anemones.
TUNZE® current: Wavebox or Turbelle® nanostream® / stream in wave mode with circular current of the filter pump.

Cross-over zone / micro atolls

Cross-over zone / micro atolls

Average current with small waves; high tide and low tide slightly noticeable. This zone contains the first coral formations.
TUNZE® current: Wavebox or Turbelle® nanostream® / stream in wave mode with Multicontroller / SmartController 7000 or 2 Turbelle® nanostream® / stream with Multicontroller / SmartController 7000.

Inner reef edge

Inner reef edge

Stronger current influenced by tidal action, but low lapping of waves. Illumination is very important in this zone and produces magnificent growth of corals.
TUNZE® current: Wavebox or Turbelle® nanostream® / stream in wave mode plus Turbelle® nanostream® / stream with Multicontroller / SmartController 7000 or only 2 Turbelle® nanostream® / stream with Multicontroller / SmartController 7000.

Reef top

Reef top

Strong current influenced by tidal action and breaking of waves. The growth of coral is very dense in this zone.
TUNZE® current: Wavebox with operation in night mode plus two Turbelle® nanostream® / stream / masterstream with Multicontroller / SmartController 7000 or Turbelle® stream with Turbelle® e-jet with Multicontroller / SmartController 7000 or two Turbelle® masterstream with Multicontroller / SmartController 7000.

All matching accessory articles

Safety Connector

Safety Connector

Enables normal operation using the TUNZE® power supply and will switch to a battery or DC supply automatically in the case of a power failure.

6105.500
55.28 USD
Including VAT: (0.00 %)
Moonlight Turbelle®

Moonlight Turbelle®

With photo diode. Simulates a 29-day moon phase and controls the night-time reduction at pumps with a Turbelle® controller add-on or together with SmartController 7000. Suitable for all Turbelle® electronic...

7097.050
34.35 USD
Including VAT: (0.00 %)
Cable 1.2 m (47.24") Turbelle® controller

Cable 1.2 m (47.24") Turbelle® controller

Connects two Turbelle® controllers for a simultaneous controlling or connects one Turbelle® controller with
a Multicontroller.

7092.300
10.70 USD
Including VAT: (0.00 %)
Y adapter cable

Y adapter cable

Connects two Turbelle® controllers for simultaneous controlling. An additional third pump or Moonlight 7097.050 can be connected. Connects SmartController 7000 with Turbelle® pumps and / or TUNZE® LEDs or the...

7090.300
19.14 USD
Including VAT: (0.00 %)
SmartController 7000

SmartController 7000

Scope of delivery:
SmartController, temperature probe,
4 connection cables, mounting set.
Suitable for devices with Wifi and browser.
Dimensions without mount (L x W x H):...

7000.000
354.75 USD
Including VAT: (0.00 %)
Turbelle® controller add-on

Turbelle® controller add-on

The Turbelle® controller is a pump controller for all Turbelle® pumps with an electric motor, which is used to set the variable pump performance – especially for models without an...

7090.000
53.28 USD
Including VAT: (0.00 %)
Multicontroller 7095

Multicontroller 7095

The TUNZE® Multicontroller 7095 is a digital control device for all Turbelle® pumps fitted with an electronic motor. It simulates the various maritime flow conditions within the aquarium, contains an...

7095.000
290.01 USD
Including VAT: (0.00 %)
Multicontroller 7096

Multicontroller 7096

The TUNZE® Multicontroller 7096 can be used for controlling all Turbelle® pumps featuring electronic motors. The controller is configurable and can be programmed using a computer with USB connectivity. It...

7096.000
117.84 USD
Including VAT: (0.00 %)
Multicontroller 7097 USB

Multicontroller 7097 USB

The Multicontroller 7097 is a controller for all Turbelle® pumps fitted with an electronic motor and TUNZE® LEDs, which can be adjusted and programmed by a computer via USB connection....

7097.000
179.19 USD
Including VAT: (0.00 %)
pH/CO2 SmartController

pH/CO2 SmartController

The pH/CO2 SmartController is a compilation consisting of the SmartController 7000 and the following accessories:
- 7070.200 CO2 valve set, including non-return valve and hose
- 7070.110 pH electrode made...

7070.000
539.96 USD
Including VAT: (0.00 %)
Redox Controller

Redox Controller

Le contrôleur rédox est un assemblage de composants comme
le SmartController 7000 et les accessoires suivants :
- 7070.120 Controlled Power Socket, prise commandée
- 7055.100 mV électrode en...

7075.000
645.81 USD
Including VAT: (0.00 %)
Temperature Controller

Temperature Controller

The Temperature Controller is a compilation consisting of the SmartController 7000 and its appropriate switching socket, the Controlled Power Socket 7070.120 in a separate package.

7028.000
426.27 USD
Including VAT: (0.00 %)
Nanostream® Rock

Nanostream® Rock

For Turbelle® nanostream® 6015, 6025, 6045 and 6055. Consisting of a highly porous ceramic stone with Live Rock Function, suitable for fresh and sea water, and a high water flow...

6025.250
54.12 USD
Including VAT: (0.00 %)
Cable guard

Cable guard

Cable protection hose, length 33 cm (13 in.), suitable for the cable of the Turbelle® pumps, for example, to protect against damage by sea urchins, if the pump is located...

6040.019
2.16 USD
Including VAT: (0.00 %)
Magnet holder

Magnet holder

Universal holder for attachment up to a glass thickness of 20 mm (¾")
Dimensions: ø50 mm (1.9") x W15 mm (.59")

6025.500
49.39 USD
Including VAT: (0.00 %)

The prices listed in the catalogue are given in USD and contain a value-added tax of 0%. Additional information: