LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum
LED full spectrum

LED full spectrum

Suitable for stony coral aquariums up to approx. 40 liters (11 USgal.), soft coral aquariums up to approx. 60 liters (16 USgal.), and freshwater aquariums up to approx. 80 liters (21 USgal.).
Equipped with 76 1-watt LEDs with Ultra Low Current Technology. Cold white, blue LEDs (450 nm), green and red LEDs for an adjustable light spectrum from > 13,000 K up to pure blue light.
Manuall adjustment with included magnet holder, alternatively with separately available Multicontroller 7097 or SmartController 7000.
Active power control: The power is adjusted depending on the luminaire temperature in order to protect the LED as much as possible.
Permanently usable under water: the improved cooling increases the output up to a maximum of 26 W total output, correspondingly, the brightness and photosynthetically active radiation.
Factory settings in air:
Color temperature: approx. 30,000 K
Perceived brightness: 400 lm
Photosynthetically Active Radiation Flux (PAR): 2.2 W
Photosynthetic photon flux: 9.2 µmol / s
Power consumption: 9.5 W
Power supply: 100-240V/50-60Hz.
Magnet Holder for a glass thickness up to 12 mm (1/2").
Dimensions without holder (L x W x H): 305 x 25 x 13 mm (12 " x 1 " x .7")
Cable length: 2.5 m (98.4")
This lamp is intended exclusively for illuminating aquariums and contains built-in LED bulbs. The bulbs in the lamp can not be replaced.

Instructions for use
All matching accessory articles
8850.000
164.99 USD





Specifications

LED full spectrum 8850

LED full spectrum 8850

The LED full spectrum 8850 is equipped with 76 1-watt LEDs with Ultra Low Current Technology, cold white, blue LEDs (450 nm), as well as green and red LEDs for an adjustable light spectrum from > 13,000 K up to pure blue light. Through the use of state-of-the-art components, a small housing was developed which can be flexibly attached with the Magnet Holder. The special manufacturing process doesn't only guarantee the water resistance, it also enables the permanent underwater operation. Hereby, it increases its performance to 26 W and thus relieves the aquarium heater. The functionality to perform a contact free adjustment of the spectrum with the included Magnet Holder has also been added. Any color temperature from 5,000 K can be set. The air-cooled LED always regulates itself to the maximum output power of 9,5 W for every spectrum. 24 V low voltage minimizes electrical losses.

24 V low voltage minimizes...

electrical losses

Energy Saving

Magnet Holder for a glass...

thickness of up to 12 mm (1/2")

Housing made of corrosion-resistant plastic

Temperature sensor enables a performance...

optimization under any conditions

Aluminum to reduce the thermal...

resistance

Innovative support for a discrete...

and flexible installation

LED PU-resin for IP 68...

safety

Cooling ribs to increase heat...

dissipation

High-quality Osram brand-name LEDs

Housing with reflective white inner...

surface for minimal losses caused by scattered light

Moonlight LED

Contact-free sensor for color setting

All matching accessory articles

Safety Connector

Safety Connector

Enables normal operation using the TUNZE® power supply and will switch to a battery or DC supply automatically in the case of a power failure.

6105.500
59.79 USD

The prices listed in the catalogue are given in USD and contain a value-added tax of 0%. Additional information: